|
[Sponsors] |
January 12, 2012, 21:24 |
Y+ precision
|
#1 |
New Member
|
hello for everybody ,
i have tow questions 1- i know that for turbulence model spalart allmar the Y+ must be in greater then 30 or around the value 1 , i refin so much my grid near then wall i obtained Y+ around the value 0.048 in maximun , is it true to use this gid or i will enlarge my grid . 2- in ANSYS Fluent 13 is there an option to detrminate the centre of pressure ( forces ) in the airfoil for exemple if yes please to anwer me thank you for all |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Switch from single precision to double precision | kk81 | OpenFOAM Bugs | 0 | March 11, 2010 06:14 |
Number of elements x double precision | matheusguzella | ANSYS Meshing & Geometry | 2 | October 7, 2009 10:15 |
CFX Pre/Double Precision | Scott Nordsen | CFX | 4 | July 22, 2009 18:45 |
what's wrong about my code for 2d burgers equation | morxio | Main CFD Forum | 3 | April 27, 2007 10:38 |
double precision assigning in FRTRAN | R.A.Khurram | Main CFD Forum | 12 | October 2, 2001 11:00 |