|January 20, 2012, 09:07||
Mesh Element No.
Join Date: Jun 2011
Posts: 20Rep Power: 6
i ha ve a doubt in my mind. I am doing CFD simulation of a compressor while doing the meshing in ICEM CFD the no. of elements shown were 5,20,000 but when i transferred the mesh to CFX-Pre no. of elements shown in the mesh statistics were less than as shown in the ICEM CFD. Can any one tell me the reason behind this?
It will be a very big help to me.
Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|No layers in a small gap||bobburnquist||OpenFOAM Native Meshers: snappyHexMesh and Others||6||August 26, 2015 09:38|
|discretizer - gmshToFoam||Andyjoe||Open Source Meshers: Gmsh, Netgen, CGNS, ...||13||March 14, 2012 05:35|
|[ICEM] Problem making structured mesh on a surface||froztbear||ANSYS Meshing & Geometry||4||November 10, 2011 09:52|
|Negative element volume & folded mesh in cfx 11.0||siavash ghassemi||CFX||2||December 28, 2007 14:17|