 |
 |
 |
|
|
|
[Sponsors] | ||||
January 20, 2012, 08:07
|
Mesh Element No.
|
#1 |
|
New Member
anil
Join Date: Jun 2011
Location: chennai
Posts: 20
Rep Power: 14  |
i ha ve a doubt in my mind. I am doing CFD simulation of a compressor while doing the meshing in ICEM CFD the no. of elements shown were 5,20,000 but when i transferred the mesh to CFX-Pre no. of elements shown in the mesh statistics were less than as shown in the ICEM CFD. Can any one tell me the reason behind this?
It will be a very big help to me. Thanks in advance. Regard, Anil |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [Gmsh] discretizer - gmshToFoam | Andyjoe | OpenFOAM Meshing & Mesh Conversion | 13 | March 14, 2012 04:35 |
| [ICEM] Problem making structured mesh on a surface | froztbear | ANSYS Meshing & Geometry | 4 | November 10, 2011 08:52 |
| Negative element volume & folded mesh in cfx 11.0 | siavash ghassemi | CFX | 2 | December 28, 2007 13:17 |
1Likes
Linear Mode
