CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Mesh Generation & Pre-Processing (http://www.cfd-online.com/Forums/mesh-generation/)
-   -   How to start with Grid Generation/Meshing (http://www.cfd-online.com/Forums/mesh-generation/116736-how-start-grid-generation-meshing.html)

VSass April 24, 2013 06:40

How to start with Grid Generation/Meshing
 
Hello,

i'm not sure if this is the proper forum for my question,but i want to ask for some basics/fundamentals in grid generation. To be more precise, i want to read about constructing meshes, alone or from cad geometries. Are there any books for beginners? Also, from the known softwares (Ansys,Gambit etc), which is more friendly for amateurs?

Thanks in advance

sameben April 24, 2013 06:45

Hi ,
Are you from the academia or the industry?

VSass April 24, 2013 06:49

Thanks for the quick reply!

I'm an undergraduate student working on a thesis on CFD, and i want to extend my knowledge to grid generation as deeply as possible, in order to be able to construct and examine any geometry i want.

sameben April 24, 2013 08:09

Can I have your email?

sameben April 24, 2013 08:22

You should be able to find a lot of papers authored by Dr. Peter Eiseman here

http://www.gridpro.com/publications/names/40/pages/2

jchawner July 21, 2013 17:46

Thompson's book is a classic (and freely available online).

http://www.erc.msstate.edu/publications/gridbook/


All times are GMT -4. The time now is 11:15.