|
[Sponsors] |
July 28, 2013, 15:04 |
Mesh stucks up in Icem
|
#1 |
New Member
Join Date: May 2013
Posts: 6
Rep Power: 12 |
Hi!
I am using icem cfd to surfce mesh spheres of 3 mm dia, it does fine for 50 spheres, I hv 64 bit mc with 64gb ram. But when I increase the no of spheres by 400 it gets stuck up at 15 percent and doesn't move further. Any help would be appreciated... |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 04:19 |
[ANSYS Meshing] Question about ICEM mesh output to CFX | lnk | ANSYS Meshing & Geometry | 0 | July 27, 2012 16:39 |
ICEM Edit Mesh | blackbody | ANSYS Meshing & Geometry | 3 | March 8, 2010 03:49 |
Boddy fitted Hexcore Mesh in ICEM Cfd | Mitch | CFX | 0 | December 29, 2008 07:07 |
ICEM clustering of mesh points and multiple edges | webhaw | CFX | 4 | July 25, 2007 17:29 |