 |
 |
 |
|
|
|
[Sponsors] | ||||
May 31, 2016, 01:50
|
Mesh Generation in ICEMCFD
|
#1 |
|
New Member
Ahilan
Join Date: May 2016
Posts: 1
Rep Power: 0  |
I am very new to ICEM CFD. I am now trying to create a mesh for a 2D Axi-symmetric geometry. I created the geometry using the points and lines.Created a surface out of the whole curve and named it, then i tried to do 2D Surface Blocking but this error came up "Please create Topology and try again".
Can anyone pls tell me what is the problem and how to get rid of this?? |
|
|
|
|
|
June 26, 2016, 10:37
|
|
#2 |
|
New Member
Manigandan.R
Join Date: Mar 2011
Posts: 10
Rep Power: 15 |
shalli help you you?
|
|
|
|
|
|
 |
| Tags |
| icemcfd axisym mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [ANSYS Meshing] Question about mesh generation learning | lnk | ANSYS Meshing & Geometry | 2 | July 7, 2012 06:45 |
| ISAAC code mesh generation | morteza08 | Main CFD Forum | 0 | June 15, 2012 09:26 |
| General questions on grid-based computing | Adrin Gharakhani | Main CFD Forum | 21 | June 5, 2000 13:47 |
Linear Mode
