|
[Sponsors] |
September 23, 2016, 10:31 |
Problem in volume meshing
|
#1 |
New Member
vikrant
Join Date: Jun 2014
Posts: 4
Rep Power: 11 |
Hi,
I am modelling a car cabin using StarCCM+. Wrapping and surface meshing has been successfully completed but I am facing problem in volume meshing. I am getting following error: SERIAL_FATAL:Subsurfacer:: CheckTrueIntersection: Original surface is self intersecting. I have checked remeshed surface but there are zero self intersecting surfaces. Can any one please tell me the possible reason of error? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Volume Meshing Problem; YOUR GEOMETRY HAS A HOLE | mariachi | ANSYS Meshing & Geometry | 5 | May 30, 2018 03:52 |
[Gmsh] Problem meshing with larger control volume | gex | OpenFOAM Meshing & Mesh Conversion | 0 | June 15, 2016 06:03 |
Gambit meshing problem to following geometry | ahmadmln | ANSYS Meshing & Geometry | 2 | October 21, 2014 02:49 |
Volume meshing problem | Tensian | enGrid | 1 | January 23, 2014 18:06 |
[ICEM] Meshing the Fluid Volume of a Fibrous Membrane/Media--Help with errors/settings? | ANT | ANSYS Meshing & Geometry | 4 | July 10, 2013 01:20 |