|
[Sponsors] |
Question about the 'undo' button in Autogrid5 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 19, 2012, 05:30 |
Question about the 'undo' button in Autogrid5
|
#1 |
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 15 |
Hi,
May I ask if there's an undo button in Autogrid5?
__________________
Best regards, Meimei |
|
September 19, 2012, 08:27 |
|
#2 |
New Member
majid
Join Date: Jan 2012
Posts: 14
Rep Power: 14 |
you cannt use undo bottom in autogrid5
but you can do your word again and this dont take very time |
|
September 20, 2012, 16:34 |
|
#3 | |
Senior Member
Meimei Wang
Join Date: Jul 2012
Posts: 494
Rep Power: 15 |
Quote:
What do you mean by 'do my word'? Thanks!
__________________
Best regards, Meimei |
||
September 21, 2012, 10:56 |
|
#4 |
New Member
majid
Join Date: Jan 2012
Posts: 14
Rep Power: 14 |
Dear anna
In auto grid,fine turbo and .... in NUMECA's software you can not use undo you must to do it again |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Block refinement button | Anna Tian | ANSYS Meshing & Geometry | 5 | August 11, 2012 12:45 |
[ICEM] Question about the button 'transform geometry also' | Anna Tian | ANSYS Meshing & Geometry | 4 | July 30, 2012 13:52 |
Question Re Engineering Data Source | imnull | ANSYS | 0 | March 5, 2012 13:51 |
internal field question - PitzDaily Case | atareen64 | OpenFOAM Running, Solving & CFD | 2 | January 26, 2011 15:26 |
CHANNEL FLOW: a question and a request | Carlos | Main CFD Forum | 4 | August 23, 2002 05:55 |