Improve Grid Quality with Autogrid -- CFD Online Discussion Forums

October 7, 2013, 04:46	Improve Grid Quality with Autogrid	#1
Polito New Member Join Date: Oct 2013 Posts: 4 Rep Power: 12	Hello, Iam a beginner in using numeca/autogrid. I have to apply hub fillets at a given geometry. I imported the geometry successfully and applied hub fillets with different radius. Unfortunalley the grid quality, mainly the min. skewness, is quite bad. iam trying to reach angles about 22 grad but by increasing the radius the min. skewness is getting worse. My question is: How can I increase the skewness angle and the quality? Are there any tools in autogrid? I would be very thankful about your help!

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Quality problem adjusting grid with y+	earth07	ANSYS Meshing & Geometry	1	July 24, 2013 11:07
[ICEM] Hex refinement negative quality afterwards	Anorky	ANSYS Meshing & Geometry	8	March 22, 2010 03:25
Improve smoothness & quality of structured grid	quarkz	Main CFD Forum	2	March 10, 2007 15:26
Combustion Convergence problems	Art Stretton	Phoenics	5	April 2, 2002 05:59
Algebraic Multigrid for nonuniform grid	Joshua Lee	Main CFD Forum	4	March 16, 2000 13:05

All times are GMT -4. The time now is 02:17.