CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   NUMECA (http://www.cfd-online.com/Forums/numeca/)
-   -   Hexpress: Refinement Box definition (http://www.cfd-online.com/Forums/numeca/128239-hexpress-refinement-box-definition.html)

timfranke January 7, 2014 08:10

Hexpress: Refinement Box definition
 
Hello,

defining a refinement box in the domain by clicking two corner points on the
screen is in some occasions not very convenient when you want
to have your box at a specific location.
Are there alternative ways for definition by typing the coordinates
of the two corner points?
Or even better import an stl-file that defines the refinement region?

Regards,
Tim

colinda1 January 16, 2014 11:18

Dear Tim,
When you have selected to create a new box, you can left-click in the section at the bottom (just below the black bar) that indicates: Enter >>
With the cursor in this line you can then type the x y and z coordinates separated by a blank space and confirmed by pressing Enter. Then you can type the coordinates of the second point in the same way.

Alternatively you could write a tiny macro containing the command:
create_refinement_cube(x1, y1, z1, x2, y2, z2)
but probably through the GUI on the Enter line is easiest.



All times are GMT -4. The time now is 03:29.