|February 1, 2014, 04:52||
Flow Solver: Run time error
Join Date: Dec 2013
Posts: 2Rep Power: 0
i am trying to run a simulation in FineOpen. The taskmanager starts but after a time it aborts an the message "Flow Solver: Run time error" appears to me.
Can anybody help me?
Where is the problem?
Thanks in advance
|February 6, 2014, 04:33||
Join Date: May 2012
Posts: 52Rep Power: 5
Did the computation start to iterate?
You can see this by opening the .res file in the monitor. If so, then you'll need to analyse the reason for divergence e.g. by saving the solution just before divergence. If it did not start to iterate probably the information at the end of the .std file will tell you more about the cause.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Undeclared Identifier Errof UDF||SteveGoat||Fluent UDF and Scheme Programming||7||October 15, 2014 07:11|
|AMI speed performance||danny123||OpenFOAM||19||October 24, 2012 07:44|
|groovyBC||sega||OpenFOAM Running, Solving & CFD||12||February 17, 2010 10:30|
|Installation OF1.5-dev||ttdtud||OpenFOAM Installation||46||May 5, 2009 02:32|
|error while compiling the USER Sub routine||CFD user||CFX||3||November 25, 2002 16:16|