|May 6, 2014, 09:32||
Join Date: Jan 2014
Posts: 10Rep Power: 3
May someone help me.
I import a STL file into HEXPRESS.
After create a domain in the STL Manipulation, this statement are emerge..
**Warning: Critical problems have been detected with the domain
**Domain check: Edges with sharp angles - edge 1
Then I continued with Automation Edge Merge and Automation Face Merge in the Domain Manipulation. However, my Mesh Wizard still unable to use.
How I want to solved this problem in order to able doing the mesh?
|May 8, 2014, 22:38||
I am assuming you are working on INTERNAL FLOW. If I could assume again you have no quality issue from your original geometry (Well, some time when you converted from your original cad file to universal which in case in STL, it may cost some lost of quality), then you may not enough to specified a good resolution representation of your domain by adjusting the surface, curve resolution and other parameters as well.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[Other] Hex meshing problem DM12||patrick||ANSYS Meshing & Geometry||7||January 9, 2015 08:21|
|Problem with querying the meshing database in CFX-Pre||ashtonJ||CFX||4||August 15, 2014 20:55|
|[ANSYS Meshing] Inflation - Airfoil Meshing - Divergence problem||dalecooper||ANSYS Meshing & Geometry||0||July 19, 2013 07:04|
|Meshing problem in GAMBIT||Vidya Raja||FLUENT||0||May 20, 2006 23:31|
|GAMBIT meshing problem||Gauthier Lambert||Main CFD Forum||1||August 3, 2000 09:22|