Home > Forums > NUMECA

cfview

Mark Forums Read

Reply

February 29, 2004, 02:34	cfview	#1
fishcuter Guest Posts: n/a	Hello, I am using H-O-H type mesh to calculate flow inside cascade. Results are good, but divide in two adjacent passages. I wish to have the results on one s3 surface in one passage without showing blades. Who knows to do it in CFView ?

Reply

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Can CFview reads CGNS ?	Vinayender	NUMECA	11	May 10, 2011 07:32
Can CFview read CGNS file ?	Vinayender	Main CFD Forum	0	May 23, 2008 05:28
CFView run on the Suse10.2 system has an erro	exergy	NUMECA	2	September 26, 2007 05:36
CFView run on the suse10.2 has an erro	exergy	NUMECA	0	August 18, 2007 22:42
cfview in cascade	fishcuter	NUMECA	0	February 29, 2004 02:35

All times are GMT -4. The time now is 21:06.