|
[Sponsors] |
June 30, 2008, 18:11 |
corner sepration
|
#1 |
Guest
Posts: n/a
|
I performed the RANS simulation (K-L model)for a stator compressor blade with the height of 10 cm and the inlet Mach number of 0.6. Unfortunatley the corner separation is larger than (50%)what we measured in the experiment. Is any body have any idea? how the mesh should be? (any suggestion is kindly welcome.)
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Courant no%23 and sharp corner in 3D | jam | OpenFOAM Running, Solving & CFD | 6 | November 18, 2008 08:21 |
Corner nodes and neumann bc | Neazen | Main CFD Forum | 2 | March 31, 2008 07:21 |
Node in the corner | reader | Main CFD Forum | 1 | March 21, 2003 05:51 |
Corner Point Geometry | Tareq Al-shaalan | Main CFD Forum | 0 | July 23, 2002 10:30 |
mesh generation near corner | G. Sun | Main CFD Forum | 0 | August 19, 2000 20:11 |