Autogrid: discontinuity of 90 degrees in shroud

January 26, 2009, 09:15

Hi, I'm new to AutoGrid and I have the following error message:

"Discontinuity of 90 degrees in shroud"

Here is what I do: 1- I have my CAD geometry in the IGES format and I click on "import and link CAD". 2- I select the 7 small curves that are defining the shourd and I right click on "link to shourd". I have no error message so far. 3- Then I select the 8 small curves that are defining my hub and I right clik on "link to hub". At this time, the error message displays: discontinuity of 90 degrees in the shourd.

Does anyone have an answer ?

Eric Joubarne

afeng0796 · July 21, 2009, 04:34

Dear Eric,
It may be surface,or the curves must be a entity,and the orientation must be right

January 26, 2009, 09:15	Autogrid: discontinuity of 90 degrees in shroud	#1
Eric Joubarne Guest Posts: n/a	Hi, I'm new to AutoGrid and I have the following error message: "Discontinuity of 90 degrees in shroud" Here is what I do: 1- I have my CAD geometry in the IGES format and I click on "import and link CAD". 2- I select the 7 small curves that are defining the shourd and I right click on "link to shourd". I have no error message so far. 3- Then I select the 8 small curves that are defining my hub and I right clik on "link to hub". At this time, the error message displays: discontinuity of 90 degrees in the shourd. Does anyone have an answer ? Eric Joubarne

July 21, 2009, 04:34		#2
afeng0796 New Member deng qingfeng Join Date: Jul 2009 Posts: 9 Rep Power: 16	Dear Eric, It may be surface,or the curves must be a entity,and the orientation must be right Last edited by afeng0796; July 21, 2009 at 04:42. Reason: not exactly

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
specifying tip clearance at the shroud	Mohammad	CFX	1	December 25, 2008 07:06
Hub-to-Shroud Diagramm	Arianna	CFX	0	April 17, 2007 11:01
About the using of AutoGrid 5	Wheeler	Fidelity CFD	0	November 5, 2005 07:05
Autogrid	ked	Fidelity CFD	1	August 19, 2003 10:36
how to decide the shroud and hub line	angel	Fidelity CFD	4	April 1, 2003 02:39