Periodicity in IGG

srikumar · December 21, 2009, 02:37

I wish to set rotation-type periodicity for a geometry and though i tried setting up periodicity from the 'grid' tab,the boundary conditions do not show 'PER' as a boundary condition and there seems to be not other way to set it for the corresponding walls.Somebody,please help me out!

Hamidzoka · March 11, 2010, 04:08

dear srikumar
once you set and define the type of periodicity in IGG, you should search the periodic boundries. to do this, firstly set your periodicity. then go to grid> boundry conditions. a window named "patch selector" will be appeared. pickup "search" button in the section of "connectivity(con/nmb/per/pernm)" . IGG automatically detects periodic boundries within the specified tolerence. if your model periodicity is ocrrectly chosen but IGG could not find them periodic, you can adjust the tolerance to fix the problem.
does it help?

December 21, 2009, 02:37	Periodicity in IGG	#1
srikumar New Member Srikumar Krishnamoorthy Join Date: Dec 2009 Posts: 2 Rep Power: 0	I wish to set rotation-type periodicity for a geometry and though i tried setting up periodicity from the 'grid' tab,the boundary conditions do not show 'PER' as a boundary condition and there seems to be not other way to set it for the corresponding walls.Somebody,please help me out!

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Blocking with periodicity	jsm	ANSYS Meshing & Geometry	3	December 14, 2009 01:46
Translational Periodicity / Velocity Profile	sberez	CFX	1	November 15, 2009 17:29
Periodicity in CFX	Sam S	CFX	2	August 27, 2007 00:59
translational periodicity	wasim	CFX	0	May 13, 2006 13:34
Tetra and Periodicity	Daniele	CFX	1	September 24, 2003 07:07

March 11, 2010, 04:08		#2
Hamidzoka Senior Member Hamid Zoka Join Date: Nov 2009 Posts: 282 Rep Power: 18	dear srikumar once you set and define the type of periodicity in IGG, you should search the periodic boundries. to do this, firstly set your periodicity. then go to grid> boundry conditions. a window named "patch selector" will be appeared. pickup "search" button in the section of "connectivity(con/nmb/per/pernm)" . IGG automatically detects periodic boundries within the specified tolerence. if your model periodicity is ocrrectly chosen but IGG could not find them periodic, you can adjust the tolerance to fix the problem. does it help?