 |
 |
 |
|
|
|
[Sponsors] | ||||
September 10, 2010, 03:14
|
blade to blade module
|
#1 |
|
New Member
Join Date: Sep 2010
Posts: 2
Rep Power: 0  |
I have a problem with blade-to-blade module, when it runs, it can not compute initial solution and it's error messages are :
" ! The file usrunk.bcs does not exist. Check the path of igg file" " ! The initial solution for turbomachinery cannot be computed" Can anybody help me? Thanks. |
|
|
|
|
|
June 5, 2011, 06:21
|
|
#2 |
|
Member
CJ
Join Date: Apr 2010
Location: Malaysia
Posts: 69
Rep Power: 16   |
Hi,
Could you please refer to your nearest support agent for those problem? We could not help you if you provide insufficient information. Regards CJ NUMIT Enterprise, Malaysia +6 017 656 3436 http://maccom-numit.blogspot.com http://www.numit.com.my Email : seiko.q@numit.com.my |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| force acting on gas turbine blade.... | vvj | Main CFD Forum | 1 | March 3, 2010 01:04 |
| stress analysis of a rotating beam(wind blade) | Cheyannne | ANSYS | 0 | October 19, 2009 17:06 |
| Meshing a 3D, tapered and twisted blade with Gambit-TGrid | teskio | ANSYS Meshing & Geometry | 0 | July 3, 2009 10:36 |
| Can someone PLEASE document the development version installation | bernd | OpenFOAM Installation | 76 | November 14, 2008 21:51 |
| Lamboot trouble | r2d2 | OpenFOAM Installation | 4 | October 17, 2005 04:27 |
Linear Mode
