which turbulence model is fit for low speed axial compressor？

sukiska · July 19, 2011, 11:24

hello，I am trying some k-e models in the numeca for a low speed compressor. the maxium axial velocity is 30 m/s .
I used the SA model in the past and the calculated total characteristic line has a good agreement of the test result, but the parameters distribution at the outlet section does not.
So I decided to use some k-e models yet I find that it will blow up at a bigger flow rate than SA model using k-e models or SST model of numeca. I set the total temper and pressure as inlet condition and static pressure as the outlet condition, CFL=3, the y plus <8. I do not know the reason of blow up at bigger flow rate using k-e model ,or is there some operation should be done ?
Thank you very much for your help!

ArslanOZCAN · July 20, 2011, 09:58

Hi;

Try to keep y+ value in 1-5 range and try k-epsilon (extended wall function) turbulence model. You should first try it in the design pressure, than you can try the other presures to plot the eprformance map.

July 19, 2011, 11:24	which turbulence model is fit for low speed axial compressor？	#1
sukiska New Member ski Join Date: Jul 2011 Posts: 3 Rep Power: 2	hello，I am trying some k-e models in the numeca for a low speed compressor. the maxium axial velocity is 30 m/s . I used the SA model in the past and the calculated total characteristic line has a good agreement of the test result, but the parameters distribution at the outlet section does not. So I decided to use some k-e models yet I find that it will blow up at a bigger flow rate than SA model using k-e models or SST model of numeca. I set the total temper and pressure as inlet condition and static pressure as the outlet condition, CFL=3, the y plus <8. I do not know the reason of blow up at bigger flow rate using k-e model ,or is there some operation should be done ? Thank you very much for your help!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbulence model for flow over a cylinder at Re=10000	ojha.mayank485	CFX	8	February 4, 2012 05:33
Centrifugal Pump and Turbulence Model	Michiel	CFX	12	January 25, 2010 03:20
Natural convection - Inlet boundary condition	max91	CFX	1	July 29, 2008 20:28
Turbulence Model for Rectangular Duct Flow	ken	FLUENT	4	May 26, 2005 20:39
Turbulence model in flow driven by surface tension	Z. ZENG	Main CFD Forum	7	April 28, 1999 07:18

July 20, 2011, 09:58		#2
ArslanOZCAN New Member Arslan Join Date: Jan 2011 Posts: 24 Rep Power: 3	Hi; Try to keep y+ value in 1-5 range and try k-epsilon (extended wall function) turbulence model. You should first try it in the design pressure, than you can try the other presures to plot the eprformance map.