Capillary Rise With bubbe inside problem
1 Attachment(s)
Hi Foamers,
I am trying to model capillary rise in interFoam however during my simulation in a capillary with diameter 1e-3m and height 30e-3 there seem to be bubbles appearing at the bottom which is very strange. I just wanted to see if anyone has any idea why might that be? please see photo attached to see the bug. Kind Regards Rimsha Attachment 45028 |
Hi Rimsha,
Whats your boundary condition settings at the inlet? |
Hi kmooney
thank you for the reply, i have the following inlet conditions: alpha.water: inlet { type inletOutlet; value uniform 1; inletValue uniform 1; } p_grh inlet { type fixedValue; value uniform 0; } velocity: inlet { type pressureInletOutletVelocity; value uniform (0 0 0); } |
I would retry the case with alpha inlet bc as fixedValue 1 (instead of inletOutlet) and see if that helps.
|
Hiya,
I have tried that however the deltaT becomes very small and the simulation stops as co max is exceeded. Therefore i am unable to get a solution. Kind regards Rimsha |
Are you using setFields to set the first few cells in from the inlet to alpha=1? Some simulations have strange startup effects if there is an alpha=1 inlet and the cells just inside are alpha=0.
|
Yes i am using setFields, are you suggesting i should not use fields or use either one?
|
All times are GMT -4. The time now is 17:50. |