Sample has problems with baffles propably problem with particletrackToFace

mattijs · October 19, 2007, 14:07

Looked at time 0.0032208 of mixer2D. Time 0 consists of 2 separate disconnected regions so didn't use that one.

When compared to the cell pressure in Paraview looks plausible.

gschaider · October 22, 2007, 09:20

My description above was for t=0. To be honest: I didn't look at the later timesteps, because I was using the mesh only as an example for a blockMesh-generated mesh where this occurs. The sample for t=0 looks like this:

(that's what i described in my original posting)

October 19, 2007, 14:07	Looked at time 0.0032208 of mi	#1
mattijs Super Moderator Mattijs Janssens Join Date: Mar 2009 Posts: 1,419 Rep Power: 12	Looked at time 0.0032208 of mixer2D. Time 0 consists of 2 separate disconnected regions so didn't use that one. When compared to the cell pressure in Paraview looks plausible.

October 22, 2007, 09:20	My description above was for t	#2
gschaider Assistant Moderator Bernhard Gschaider Join Date: Mar 2009 Posts: 2,269 Rep Power: 20	My description above was for t=0. To be honest: I didn't look at the later timesteps, because I was using the mesh only as an example for a blockMesh-generated mesh where this occurs. The sample for t=0 looks like this: (that's what i described in my original posting)

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sample utility problems	msrinath80	OpenFOAM Running, Solving & CFD	11	May 12, 2009 11:08
CFX-Mesh, guide vanes (baffles) and problems.	R. Janny	CFX	1	December 31, 2008 08:49
Problem with sample utility	roberthino	OpenFOAM Post-Processing	6	August 23, 2007 15:29
BAFFLES PROBLEM	subhash	CD-adapco	0	November 29, 2005 06:16
Mesh problems for a stirred vessel with baffles!	UY	CFX	0	September 14, 2005 10:19