|
[Sponsors] |
July 3, 2011, 16:19 |
paraFoam, Segmentation fault
|
#1 |
New Member
Nat
Join Date: Oct 2009
Posts: 10
Rep Power: 16 |
Hi all
I just installed openFoam on my Laptop with the Opensuse 11.4x64. I nstallation went fine until I ran paraFoam. It crashes at start with the following message: /opt/openfoam171/bin/paraFoam: line 119: 22087 Segmentation fault paraview --data="$caseFile" Any help would be much appreciated |
|
July 3, 2011, 17:59 |
|
#2 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,974
Blog Entries: 45
Rep Power: 128 |
Greetings Nat,
Try running this command before paraFoam: Code:
export LC_ALL=C Bruno
__________________
|
|
July 3, 2011, 21:24 |
|
#3 |
New Member
Nat
Join Date: Oct 2009
Posts: 10
Rep Power: 16 |
Thanks Bruno. Actually, I found that that it's a driver problem. I recently installed the fglrx driver and it didn't work out for me on my Thinkpad Duo. So by removing it and back to my previous xorg.conf resolved the issue.
I wanted to change the driver because of of the following message that i keep getting from openFoam below. Any hint? Thanks a lot p, li { white-space: pre-wrap; } X Error: GLXBadContextTag 173 Extension: 154 (Uknown extension) Minor opcode: 5 (Unknown request) Resource id: 0x260026e X Error: GLXBadContextTag 173 Extension: 154 (Uknown extension) Minor opcode: 1 (Unknown request) Resource id: 0x9a0005 X Error: GLXBadContextTag 173 Extension: 154 (Uknown extension) Minor opcode: 117 (Unknown request) Resource id: 0x9a0005 X Error: GLXBadContextTag 173 |
|
July 4, 2011, 19:04 |
|
#4 |
Retired Super Moderator
Bruno Santos
Join Date: Mar 2009
Location: Lisbon, Portugal
Posts: 10,974
Blog Entries: 45
Rep Power: 128 |
Hi Nat,
As far as I can remember, those kinds of issues usually require one or more of these solutions:
Best regards, Bruno
__________________
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Segmentation fault when running dieselFoam or dieselEngineFoam in parallel | francesco | OpenFOAM Bugs | 4 | May 2, 2017 21:59 |
Segmentation fault when starting paraFoam | gaffu | OpenFOAM Installation | 16 | November 18, 2011 19:05 |
forrtl: severe (174): SIGSEGV, segmentation fault occurred | therockyy | FLOW-3D | 7 | January 19, 2011 22:52 |
ParaView segmentation fault only for multiphase | gwierink | OpenFOAM | 9 | March 25, 2010 07:23 |
[OpenFOAM] Segmentation fault with paraFoam and paraview 3.6.1 on Fedora 11 32 and 64 bit | nanes | ParaView | 2 | September 11, 2009 09:12 |