|January 23, 2016, 08:12||
Openfoam for windows 16.02 [CFD support] -problem with paraview
Join Date: Jan 2016
Posts: 4Rep Power: 2
I have a problem with the new version of openfoam for windows (version 16.02) released by CFD support.
The problem occurs when I try to launch paraview with the command "paraview" or with the "paraFoam" command an error occurs :
"ERROR: In C:\msys\1.0\opt\ParaView-v5.0.0-RC1-source\ParaViewCore\ClientServerCore\Rendering\vtkPVSynchronizedRenderWindows.cxx, line 408 vtkPVSynchronizedRenderWindows (0x8b36760): Invalid process type. Segmentation fault
I tried to find something on internet but it didn't find anything. I also tried to install again paraview but the problem stays. I never had this problem with the last version of Openfoam windows by CFD support (version 15.06).
The installation went well, except with parallel MPI, that already was installed in my computer (maybe the problem is here, but I don't think so).
I'm using windows 10, 64 bits.
Does someone have had the same problem when installing this new version ?
Thank you in advance for your help
Last edited by ditmeyer; January 24, 2016 at 11:36.
|cfdsupport, openfoam, parafoam, paraview|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Suggestion for a new sub-forum at OpenFOAM's Forum||wyldckat||Site Help, Feedback & Discussions||20||October 28, 2014 10:04|
|Frequently Asked Questions about Installing OpenFOAM||wyldckat||OpenFOAM Installation||0||January 1, 2014 20:21|
|LINUX newbie with paraView installation problem||kenya0514||OpenFOAM Installation||4||January 16, 2013 18:51|
|Yet another Paraview problem||gascortado||OpenFOAM||5||February 21, 2010 07:39|
|OpenFOAM141 FoamX and paraView problem on cluster server||seigi||OpenFOAM Installation||1||January 28, 2008 16:44|