|
[Sponsors] |
Updating from working copy of foam-extend-3.0 to 3.1 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 7, 2014, 15:17 |
Updating from working copy of foam-extend-3.0 to 3.1
|
#1 |
New Member
Join Date: Jun 2014
Posts: 10
Rep Power: 11 |
Hi all,
Can somebody please post instructions on how to successfully update from a working copy of foam-extend-3.0 to foam-extend-3.1 ? By doing some simple search I found these instructions that were posted while 3.1 was still in testing phase: Code:
To migrate from a foam-extend-3.0 working copy: cd ~/foam sed -i 's/foam-extend-3.0/foam-extend-3.1/g' foam-extend-3.0/.git/config mv foam-extend-3.0 foam-extend-3.1 cd foam-extend-3.1 git pull git checkout nextRelease Note that work has been done also in ThirdParty, so it is a good idea to make sure that all those packages are re-compiled. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with RBF in tho Foam 3.0 extend | Vesek | OpenFOAM Programming & Development | 4 | June 16, 2014 05:22 |
Negative Cell Volume with moveDyMEngineMesh with Foam Extend 3.0 | RJ87 | OpenFOAM | 2 | May 8, 2014 13:13 |
[swak4Foam] Basic Error when installing swak4foam with foam extend 3.0 | mnobrega | OpenFOAM Community Contributions | 6 | April 1, 2014 02:47 |
[Other] cgnsToFoam problems with "QUAD_4" cells | lentschi | OpenFOAM Meshing & Mesh Conversion | 1 | March 9, 2011 05:49 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 20:08 |