CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Installation (http://www.cfd-online.com/Forums/openfoam-installation/)
-   -   Paraview is very slow (http://www.cfd-online.com/Forums/openfoam-installation/57744-paraview-very-slow.html)

chnrdu May 30, 2005 06:44

starting paraview takes me 10
 
starting paraview takes me 10 minutes, I think there is something wrong.


do u think i should install VTK?

Following is copied from paraview's help->about paraview 1.8

ParaView was developed by Kitware Inc.
http://www.paraview.org
http://www.kitware.com
This is version 1.8, release 5

Runtime information:
Software Rendering: Disabled
Satellite Software Rendering: Disabled
Stereo Rendering: Disabled
Offscreen Rendering: Disabled
Tiled Display: Disabled
Using RenderingGroup: Disabled
Render Module Used: LODRenderModule
Network Configuration: (none)
Cave Configuration: (none)
Compositing: Enabled
BatchScriptName: (none)
PlayDemoFlag: 0
DisableRegistry: 0
CrashOnErrors: 0
Port: 11111
StartEmpty: 0
Username: (none)
HostName: localhost
ParaViewScriptName: paraFoam.pvs
ParaViewDataName: (none)

Tcl/Tk
- Copyright (c) 1989-1994 The Regents of the University of California.
- Copyright (c) 1994 The Australian National University.
- Copyright (c) 1994-1998 Sun Microsystems, Inc.
- Copyright (c) 1998-2000 Ajuba Solutions.


All times are GMT -4. The time now is 12:19.