|
[Sponsors] |
March 10, 2011, 13:17 |
problem with libmpi.so.0
|
#1 |
New Member
John Spiropoulos
Join Date: Oct 2009
Location: Stuttgart
Posts: 4
Rep Power: 16 |
Hi there
i'm a newbie in linux/openfoam and i have this problem: i installed openfoam on my notebook (opensuse 11.3 32bit) following the instructions. it seemed all to be correct and then i ran the cavity example. blockmesh, icofoam worked and paraview started but it stuck. i waited for 5 minutes but nothing happened i had no control over the machine. i pressed the off button and when i rebooted and tried to run the cavity example again i took the message by blockmesh: blockMesh: error while loading shared libraries: libmpi.so.0: cannot open shared object file: No such file or directory i checked in yast the mpi lib and found out that libmpi.so.0 exists on the system. i tried other examples but took the same message. can anybody help me? Last edited by Spiro; March 10, 2011 at 17:56. |
|
March 11, 2011, 04:53 |
|
#2 |
New Member
John Spiropoulos
Join Date: Oct 2009
Location: Stuttgart
Posts: 4
Rep Power: 16 |
ok the problem is solved. although i dont understand how...
i just ran the failsafe mode of suse and by rebooting everything worked. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Incoherent problem table in hollow-fiber spinning | Gianni | FLUENT | 0 | April 5, 2008 10:33 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |