CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Native Meshers: blockMesh (http://www.cfd-online.com/Forums/openfoam-meshing-blockmesh/)
-   -   default patches problem (http://www.cfd-online.com/Forums/openfoam-meshing-blockmesh/100613-default-patches-problem.html)

sivakumar April 27, 2012 11:10

default patches problem
 
1 Attachment(s)
Hello everyone,

I am generating mesh for one fourth of the cylinder with cyclic boundary condition,
the quarter cylinder has 4 blocks,
while executing blockMesh, it is generating mesh with some warning.
I tried so many times but, i am not able to find the problem.

I have attached the blockMeshDict file please have a look and help me to sort out this issue.

with regards,
Sivakumar

sivakumar May 1, 2012 04:53

Hello Guys,
Until now there is no reply for this issue, however I have solved the problem.
the problem was blocks, the geometry had 4 blocks, now changed in to 6 blocks.
now the the problem has been solved.
I have attached the blockMeshDict and the mesh output. (old and new)
please have a look.

with regards,
Sivakumar

sivakumar May 1, 2012 05:04

1 Attachment(s)
Hello Guys,
Until now there is no reply for this issue, however I have solved the problem.
the problem was blocks, the geometry had 4 blocks, now changed in to 6 blocks.
now the the problem has been solved.
I have attached the blockMeshDict and the mesh output. (old and new)
please have a look.

with regards,
Sivakumar


All times are GMT -4. The time now is 04:52.