Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[blockMesh] How to get start and end tangent for spline edge

Mark Forums Read

Reply

Search this Thread

September 26, 2012, 06:32	How to get start and end tangent for spline edge	#1
A.A. Member Alexander A Join Date: Jun 2012 Posts: 53 Rep Power: 13	Hi, Does anybody know how to get a start and end tangent for a spline edge? If it is possible please can you post the syntax for it. Many thanks, Alex

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Centrifugal fan-reverse flow in outlet lesds to a mass in flow field	xiexing	CFX	3	March 29, 2017 10:00
Error - Solar absorber - Solar Thermal Radiation	MichaelK	CFX	12	September 1, 2016 05:15
Problem with an old Simulation	FrankW	CFX	3	February 8, 2016 04:28
An error has occurred in cfx5solve:	volo87	CFX	5	June 14, 2013 17:44
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05

All times are GMT -4. The time now is 06:42.