CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Native Meshers: blockMesh (http://www.cfd-online.com/Forums/openfoam-meshing-blockmesh/)
-   -   How to mesh in a cylinder? (http://www.cfd-online.com/Forums/openfoam-meshing-blockmesh/109225-how-mesh-cylinder.html)

mscheng November 12, 2012 23:22

How to mesh in a cylinder?
 
I want to generate mesh in a cylinder, and how to?

vbchris November 21, 2012 22:26

I just did some work with this.
I found a good way to prevent skew near the center is to mesh a square in the center and then two block on adjacent faces of the original block with arc'ed outer edges.
I assumed axi-symmetric geometry and only meshed 1/4 of the cylinder.


All times are GMT -4. The time now is 16:51.