 |
 |
 |
|
|
|
[Sponsors] | ||||
November 12, 2012, 22:22
|
How to mesh in a cylinder?
|
#1 |
|
New Member
Maosong Cheng
Join Date: Aug 2012
Posts: 19
Rep Power: 13  |
I want to generate mesh in a cylinder, and how to?
|
|
|
|
|
|
November 21, 2012, 21:26
|
|
#2 |
|
Member
Chris L
Join Date: Sep 2012
Posts: 53
Rep Power: 13 |
I just did some work with this.
I found a good way to prevent skew near the center is to mesh a square in the center and then two block on adjacent faces of the original block with arc'ed outer edges. I assumed axi-symmetric geometry and only meshed 1/4 of the cylinder. |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] 3-D Mesh in a cylinder | Nikunj.R | OpenFOAM Meshing & Mesh Conversion | 32 | July 9, 2023 13:22 |
| [blockMesh] Cylinder mesh using blockMesh with m4 macro | Lewis Liang | OpenFOAM Meshing & Mesh Conversion | 2 | November 21, 2017 02:28 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| rotating cylinder using sliding mesh | Tim Daly | FLUENT | 1 | November 9, 2008 23:02 |
Linear Mode
