CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   OpenFOAM Native Meshers: blockMesh (http://www.cfd-online.com/Forums/openfoam-meshing-blockmesh/)
-   -   Number of edges not aligned with or perpendicular to non-empty directions (http://www.cfd-online.com/Forums/openfoam-meshing-blockmesh/116155-number-edges-not-aligned-perpendicular-non-empty-directions.html)

am9109 April 14, 2013 07:33

Number of edges not aligned with or perpendicular to non-empty directions
 
Hey all,

I'm trying to model a wind tunnel section with a flat plate going across from side to side, blockMesh works but in checkMesh I get the folowing message:
"Number of edges not aligned with or perpendicular to non-empty directions"

Does anyone know which changes I could try to make to fix this problem?

Thanks a lot,

Alex


All times are GMT -4. The time now is 01:09.