CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[blockMesh] blockMesh | MergePatchPairs | snappyHexMesh |Different number of cells in divisions

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   October 25, 2013, 12:49
Default blockMesh | MergePatchPairs | snappyHexMesh |Different number of cells in divisions
  #1
Member
 
Join Date: Oct 2012
Posts: 32
Rep Power: 13
pythag0ra5 is on a distinguished road
Hi there,

i have a question concerning blockMesh, especcially the mergePatchPair-section. I would like to create 2 blocks (block I and block II) as you can see in the image below. One can see, that these blocks should have different numbers of cells in the y-direction.

If i run blockMesh, i receive my desired mesh. But if i run snappyHexMesh afterwards, i receive an error like:

Code:
--> FOAM FATAL ERROR:
cell 934000 of level 0 uses more than 8 points of equal or lower level
Points so far:8(473280 473470 473660 511470 511660 511850 985911 985971)
If i modify the blocks in blockMesh so that block I and II has the same number in the y-direction, either blockMesh and snappyHexMesh produces a mesh.

Do you have any hints for me in order to obtain my desired mesh (in snappyHexMesh)?

Best regards!


pythag0ra5 is offline   Reply With Quote

Old   September 19, 2020, 15:38
Default
  #2
Member
 
Join Date: Apr 2015
Posts: 42
Rep Power: 10
HosseinB is on a distinguished road
I am having the same issue. Did you find an answer to this?


Thanks
HosseinB is offline   Reply With Quote

Reply

Tags
blockmesh, mergepatchpairs, snappyhexmesh

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[snappyHexMesh] sHM layer process keeps getting killed MBttR OpenFOAM Meshing & Mesh Conversion 4 August 15, 2016 04:21
[snappyHexMesh] No layers in a small gap bobburnquist OpenFOAM Meshing & Mesh Conversion 6 August 26, 2015 10:38
Compressor Simulation using rhoPimpleDyMFoam Jetfire OpenFOAM Running, Solving & CFD 107 December 9, 2014 14:38
killed "snappyHexMesh" parkh32 OpenFOAM Pre-Processing 2 April 8, 2012 18:12
[snappyHexMesh] snappyHexMesh aborting Tobi OpenFOAM Meshing & Mesh Conversion 0 November 10, 2010 04:23


All times are GMT -4. The time now is 11:52.