|
[Sponsors] |
[blockMesh] Wedge type mesh: generation OK but the mesh has bug for some cells! |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 13, 2014, 04:50 |
Wedge type mesh: generation OK but the mesh has bug for some cells!
|
#1 |
New Member
Fabien DOS SANTOS
Join Date: Oct 2009
Location: Nevers, FRANCE
Posts: 8
Rep Power: 16 |
Hello,
I'm working on a case (flow inside a nozzle) where my geometry is axisymmetric and I want to do simulation with only one quarter of it (for cpu time saving). I create my mesk by generating a .m4 file with Matlab and then create a blockMeshDict file with this .m4 file (I know that can sound complicated, but it works). The mesh is generating without any problem. But I have a block that gets some bad cells (you can see it on the attached image from paraview) and I don't know why! This block has only 6 vertices because it is on the axis. I have isolated this particular block in order to understand the bug easier, here is my blockMeshDict: PHP Code:
What am I doing wrong ?? I have other blocks that have the same configuration (6 vertices, on the axis) but they are all good, I don't understand! |
|
January 13, 2014, 05:23 |
|
#2 |
New Member
Fabien DOS SANTOS
Join Date: Oct 2009
Location: Nevers, FRANCE
Posts: 8
Rep Power: 16 |
I didn't mention it, but I use openFoam 2.2.2.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
reactingMultiphaseEulerFoam | tonnykz | OpenFOAM Running, Solving & CFD | 2 | June 15, 2020 02:09 |
[Other] simulation of closing the gate using moving mesh | simin_ds | OpenFOAM Meshing & Mesh Conversion | 8 | April 12, 2019 05:49 |
Compression instead of expansion | EnricoDeFilippi | OpenFOAM Running, Solving & CFD | 1 | October 8, 2018 10:19 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |