|January 13, 2014, 17:25||
Is this a mesh problem?
Join Date: Aug 2012
Posts: 102Rep Power: 6
Hello I am using waves2Foam to simulate a modified 2D wave tank, it is a simple geometry but it has a lot of elements, I made it using blockMesh only so it is a large file
my problem is that I am getting an error and somehow I think it is because of the mesh.
As you can see in the picture the wave stops right there, it should continue along the whole tank but it just stops, I used checkMesh to see if something was wrong with the mesh but it says that the mesh is OK however I get this warning (not quite sure what it means)
--> FOAM Warning :
From function polyMesh:: polyMesh(... construct from shapes...)
in file meshes/polyMesh/polyMeshFromShapeMesh.C at line 901
Found 4 undefined faces in mesh; adding to default patch.
Anyway I can provide any file that you want to look at if you want to help me.
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to set periodic boundary conditions||Ganesh||FLUENT||13||January 22, 2014 05:11|
|Overset MESH problem DFBI 6DOF||Ale85||STAR-CCM+||0||October 1, 2013 12:25|
|[ICEM] ICEM Structured Mesh Problem||OMJT||ANSYS Meshing & Geometry||3||March 22, 2013 11:06|
|[GAMBIT] SOFC crossflow mesh possible problem???||epc1||ANSYS Meshing & Geometry||1||February 4, 2013 02:57|
|Dynamic Mesh Problem.||Tom Clark||FLUENT||9||July 7, 2010 07:56|