|
[Sponsors] |
July 11, 2015, 06:44 |
export STL format
|
#1 |
New Member
samira
Join Date: Feb 2015
Location: Iran
Posts: 16
Rep Power: 11 |
Dear all,
I write script python for geometry airfoil in Salome-Meca 2015 . when I export it to .stl, the file has only begin solid end solid and nothing in between! I would appreciate if you could send me steps for doing this export.. Best regards Samira |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM.org] Compiling OpenFOAM 5.0 on the Titan Supercomputer | wildfire230 | OpenFOAM Installation | 20 | May 6, 2020 07:30 |
[ANSYS Meshing] Automated ANSYS mesh export in ASCII (OpenFOAM) format | siny | ANSYS Meshing & Geometry | 1 | January 17, 2020 09:17 |
STL file modification and export | Crank-Shaft | Main CFD Forum | 0 | November 25, 2014 09:04 |
Unable to install OpenFOAM 1.6-ext | Maimouna | OpenFOAM Installation | 23 | May 8, 2014 05:47 |
[Workbench] Meshing and export mesh from STL geometry | alerfreire | ANSYS Meshing & Geometry | 0 | March 26, 2013 09:25 |