 |
 |
 |
|
|
|
[Sponsors] | ||||
August 5, 2009, 06:29
|
gmshToFoam
|
#1 |
|
Guest
Posts: n/a
|
Dear All,
At the time of convering gmsh mesh to Foam, I am getting following error. FOAM Warning : From function gmshToFoam in file gmshToFoam.C at line 891 Could not match gmsh face 3(91 528 90) to any of the interior or exterior faces that share the same 0th point --> FOAM Warning : Not using gmsh face 3(528 529 90) since zero vertex is not on boundary of polyMesh Has any one knows how to solve this problem? Thanks in advance Sam |
|
|
||
|
August 11, 2009, 19:05
|
|
#2 |
|
Senior Member
Steve Hansel
Join Date: Jun 2009
Location: Colorado, USA
Posts: 112
Rep Power: 16  |
Take a look at your mesh in paraFoam (paraview) and see if the loss of that one point is significant. I doubt it will be.
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] New version of gmshToFoam? | stootoon | OpenFOAM Meshing & Mesh Conversion | 7 | February 14, 2022 09:01 |
| [Gmsh] gmshToFoam problem. | nilashansen | OpenFOAM Meshing & Mesh Conversion | 11 | June 5, 2016 10:45 |
| [Gmsh] Cell to node connectivity after 'gmshToFoam' | Jibran | OpenFOAM Meshing & Mesh Conversion | 1 | June 8, 2015 09:09 |
| [Gmsh] gmshTofoam pbm with cyclicAMI | acahuzac | OpenFOAM Meshing & Mesh Conversion | 2 | October 20, 2014 03:53 |
| [Gmsh] gmshToFoam command | mvinassa | OpenFOAM Meshing & Mesh Conversion | 1 | April 25, 2014 07:36 |
Linear Mode
