CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > OpenFOAM Native Meshers: blockMesh

Blockmesh problem about skewness

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   December 1, 2006, 22:04
Default Hi everyone~~ I wrote a cyl
  #1
Member
 
Bobby
Join Date: Mar 2009
Location: wuhan, hubei, China
Posts: 33
Rep Power: 8
aderliner is on a distinguished road
Hi everyone~~

I wrote a cylinder case, and used checkmesh to check it ,it is ok~! But, after I refined it, and the terminal show as below:

--> FOAM Warning :
From function primitiveMesh::checkFaceSkewness(const bool report, labelHashSet* setPtr) const
in file meshes/primitiveMesh/primitiveMeshCheck.C at line 838
Large face skewness detected. Max skewness = 261.67262 percent.
This may impair the quality of the result.
400 highly skew faces detected.
Writing 400 skew faces to set skewFaces

Minumum edge length = 1.0466153e-05. Maximum edge length = 4.1864613e-05.

All angles in faces are convex or less than 10 degrees concave.

Face flatness (1 = flat, 0 = butterfly) : average = 1 min = 1
All faces are flat in that the ratio between projected and actual area is > 0.8

Geometry check done.

Number of cells by type:
hexahedra: 123750
prisms: 0
wedges: 0
pyramids: 0
tet wedges: 0
tetrahedra: 0
polyhedra: 0
Number of regions: 1 (OK).
Failed 1 mesh checks.


Then I try to calculate this case, but, the deltaT become to 0 soon.

How can I refine the mesh ?

Best regards~~!

Bobby
12.2
aderliner is offline   Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
BlockMesh problem pratap OpenFOAM Native Meshers: blockMesh 21 February 16, 2009 07:32
Severe nonorthogonality and severe skewness problem qtian OpenFOAM Running, Solving & CFD 2 January 22, 2008 19:47
Run blockMesh problem fpetit OpenFOAM Installation 9 January 10, 2008 06:40
Problem in Memory by running blockMesh mamaly60 OpenFOAM Running, Solving & CFD 4 November 2, 2007 14:56
Problem with blockMesh and cyclics mattijs OpenFOAM Native Meshers: blockMesh 1 May 26, 2006 06:41


All times are GMT -4. The time now is 16:23.