 |
 |
 |
|
|
|
[Sponsors] | ||||
July 15, 2010, 10:06
|
snappyHexMesh for a pipe
|
#1 |
|
New Member
Grace
Join Date: Mar 2010
Posts: 2
Rep Power: 0  |
Hello to everybody
I am very very new in OpenFoam and currently I am trying to use snappyHexMesh to create a mesh for a pipe. I produced the 3 stl files each one corresponding to inlet, outlet and shell of the pipe and my initial mesh box which i created using blockMesh. When I execute snappyHexMesh only the boundaries from the blockMesh are printed out...I get no error msg at all...Any ideas why this is happening? Your help is much appreciated Thank you Grace |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| need help about double pipe heat exchanger with chtMultiRegionSimpleFoam | wuyangzhen | OpenFOAM | 10 | December 12, 2017 00:19 |
| Snappyhexmesh vertical manifold pipe in tank [SOLVED] | spk363 | Mesh Generation & Pre-Processing | 1 | February 17, 2016 19:51 |
| [snappyHexMesh] snappyHexMesh - spiral shaped pipe internal flow | callmety | OpenFOAM Meshing & Mesh Conversion | 2 | July 30, 2015 23:28 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
| fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |
Linear Mode
