|July 28, 2010, 05:56||
small patches in big mesh
Join Date: May 2010
Posts: 27Rep Power: 7
what's the best way in blockmesh to make small patches, as you can see in the picture below? (green is a inlet)
i want to avoid nr. 2 because i want to have about 20 inlets like this and this would mean that i must describe hundrets of blocks.
Is it possible to do it like nr.3 or better like nr.1 only to define only the cell-faces which are the boundary condition?
i read something about patchTool, could this help?
i hope you can help me
Last edited by marcbest; July 28, 2010 at 09:38.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|mesh missing after export in gambit||morteza08||Main CFD Forum||0||July 23, 2010 02:19|
|small question regarding mesh export||faiz rauf||FLUENT||7||August 9, 2004 12:14|
|Mesh||Mignard||FLUENT||2||March 22, 2000 06:12|
|unstructured vs. structured grids||Frank Muldoon||Main CFD Forum||1||January 5, 1999 11:09|