|
[Sponsors] |
[surface handling] Subdivision of faceZone or baffle |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 14, 2019, 08:23 |
Subdivision of faceZone or baffle
|
#1 |
New Member
Join Date: Aug 2019
Posts: 1
Rep Power: 0 |
Hi,
I am trying to divide a faceZone (which I use as a baffle) into several smaller ones. That way, I plan to be able to specify slightly different boundary conditions for each of them. I was not able to find anything to achieve this (other than manually splitting it). The goal is to have a high number of divisions, requiring some kind of algorithm to generate them. Even going to a 1 face per baffle would be ok. Is something like this possible? Thanks |
|
August 23, 2019, 06:37 |
|
#2 |
Senior Member
|
Hi,
You can use topoSetDict to split single faceZone into multiple faceZones. But it is also kind of manual as you have to write the coordinates of each vew faceZone. Regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 09:42 |
Problems using createBaffles to create a 3D thermal baffle | zfaraday | OpenFOAM Running, Solving & CFD | 10 | September 6, 2017 17:07 |
[snappyHexMesh] handling of baffle regions or surfaces with zero thickness with snappyHexMesh | StSchiff | OpenFOAM Meshing & Mesh Conversion | 5 | March 8, 2017 09:45 |
Calculate Mass Flowrate at a faceZone with OpenFOAM4 | donQi | OpenFOAM Post-Processing | 1 | August 31, 2016 21:13 |