|
[Sponsors] |
[Other] A question about moving mesh of engineFoam |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 11, 2018, 03:33 |
A question about moving mesh of engineFoam
|
#1 |
New Member
Liuchaozhu
Join Date: May 2018
Posts: 1
Rep Power: 0 |
hi everyone,
i want to simulate the intake valve motion of a internal combustion engine using engineFoam.But the tutorial is too simple that it does not contain the valve motion.is there any way to add the intake valve into the case? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mesh Boundary Assignment Question | Wandadars | Mesh Generation & Pre-Processing | 1 | June 13, 2016 17:19 |
Force magnitude with moving mesh | fernexda | OpenFOAM Post-Processing | 3 | April 12, 2016 09:09 |
[Other] How to set up a dynamic mesh for a piston moving through a tube of variable diameter? | karkar | OpenFOAM Meshing & Mesh Conversion | 0 | July 4, 2012 06:54 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Moving (structured) mesh | Jesper | CFX | 5 | February 2, 2007 03:43 |