CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Open Source Meshers: Gmsh, Netgen, CGNS, ... (http://www.cfd-online.com/Forums/openfoam-meshing-open/)
-   -   Hybrid mesh from Salome to OpenFOAM (http://www.cfd-online.com/Forums/openfoam-meshing-open/113711-hybrid-mesh-salome-openfoam.html)

Sören Sander February 25, 2013 12:19

Hybrid mesh from Salome to OpenFOAM
 
Hello,

I tried to export a hex/tet mesh from Salome to OF. With .unv the pyramids are not exported, so I tried to export as .med and import to gmsh. Then use gmshToFoam to export to OF. But I get this error:

Does your file specify any 3D elements (hex=5, prism=6, pyramid=7, tet=4)?
Perhaps you have not exported the 3D elements?

Is there any way to export a hex/tet mesh to OF? I also tried to export a pure tet mesh (which does work with .unv export) with gmsh and the same error occurs.

Kruno February 22, 2014 11:50

Same problem here!
If you found a solution can you post it here? You would help me a lot..

Sören Sander March 7, 2014 09:16

Hi Kruno,

I could not solve the problem. Actually, my solution was to use another meshing tool...


All times are GMT -4. The time now is 15:26.