CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   Open Source Meshers: Gmsh, Netgen, CGNS, ... (http://www.cfd-online.com/Forums/openfoam-meshing-open/)
-   -   problems with all dates from polymesh,after use ideastoFoam... (http://www.cfd-online.com/Forums/openfoam-meshing-open/117409-problems-all-dates-polymesh-after-use-ideastofoam.html)

virgili May 8, 2013 04:24

problems with all dates from polymesh,after use ideastoFoam...
 
Good morning!

I am a student, i need to write my thesis about a interaction between a structure and the wind! so i though that is a good idea, make a mesh with salome and then use Openfoam! my problem is that when a export the mesh to .unv all its running, also "ideastoFoam", and chekmesh says that everything iis ok...but when i open the "point","bounday" "faces"....all created with "ideastoFoam" from "mymesh.unv" i find only this!!

FoamFile
{
version 2.0;
format ascii;
class polyBoundaryMesh;
location "constant/polyMesh";
object boundary;
}
// * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * //

0
(
)

// ************************************************** *********************** //

Nothing is inside! :-/ whats happens?
i am using "netgen 3d-1d-2d", because its a 3d structure like a membrane, and i think it is a good algorithm to mesh, am i right??

thank very much for your help!


All times are GMT -4. The time now is 18:55.