 |
 |
 |
|
|
|
[Sponsors] | ||||
August 27, 2013, 13:33
|
Gap/holes in STL Files
|
#1 |
|
New Member
Michael Ehlen
Join Date: Nov 2010
Posts: 3
Rep Power: 15  |
Hi,
I'm doing a mesh in snappy with several intersected STL files. With a coarse background mesh everything is fine. With a fine mesh, the volume is open somewhere. Is there a utility to find the whole or gap in the stl files. Due to the reason that the stl are intersected it not possible to check for open edges. Thanks |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] With FreeCAD: creating waterproof STL files? | robob | OpenFOAM Meshing & Mesh Conversion | 11 | April 29, 2018 11:33 |
| [snappyHexMesh] cellzone defined by two stl files | cbarmpar | OpenFOAM Meshing & Mesh Conversion | 0 | March 15, 2015 10:55 |
| OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
| [OpenFOAM] ParaView 3.6.1 & 3.7.0: Can't view STL files | johannes | ParaView | 2 | December 3, 2009 14:07 |
| Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
Linear Mode
