|August 27, 2013, 15:44||
GMsh - 2D working fine. 3D will not resolve.
Join Date: Jun 2013
Posts: 25Rep Power: 4
I have created a wing in a control volume and the 2D meshing looks all good but doesn't seem to want to mesh in 3D. I sat for about an hour as it kept working but didn't give a 3D mesh.
Here is a pic of the .geo with a 2D mesh on it and here is the .geo file.
I tried to use the other 3D meshers but it also says that tetgen is not compile for gmsh. Any help would be greatly appreciated.
Last edited by Phizz82; August 27, 2013 at 17:49.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Gmres fails to converge, but LU is fine||sbabbi||Main CFD Forum||1||April 11, 2013 08:54|
|paraView was working, now not working||goldbeard||OpenFOAM Installation||8||March 28, 2013 23:02|
|gmsh 2.6.0 conversion to OpenFoam 160||rosswin||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||March 5, 2013 08:34|
|Help required on working of Micro-oven||aero||CFX||4||January 19, 2007 09:21|
|Problem running FINE Turbo||Michal Vanco||NUMECA||0||June 7, 2004 06:58|