 |
 |
 |
|
|
|
[Sponsors] | ||||
March 16, 2016, 00:44
|
complex meshes using blockMesh
|
#1 |
|
Member
Divyaprakash
Join Date: Jun 2014
Posts: 69
Rep Power: 11  |
How complex a mesh can be created using blockMesh? Has anyone got any examples to share?
Thanks! |
|
|
|
|
|
March 17, 2016, 02:16
|
|
#2 |
|
Senior Member
Karl-Johan Nogenmyr
Join Date: Mar 2009
Location: Linköping
Posts: 279
Rep Power: 21 |
Only your imagination is the limit :-)
(also, probably you cannot exceed some 1 billion blocks or so due to limited lenght of 32-bit INT) |
|
|
|
|
|
|
March 17, 2016, 02:44
|
|
#3 |
|
Senior Member
Join Date: Aug 2013
Posts: 407
Rep Power: 15 |
Hi,
One further point to add is that AFAIK blockMesh runs only in serial. So in that case it also becomes a matter of how long you are willing to wait for a complicated mesh to be generated. Cheers, Antimony |
|
|
|
|
|
 |
| Tags |
| blockmesh, mesh |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mapping (interpolation) between two meshes | Ebrahim | OpenFOAM Programming & Development | 2 | June 15, 2020 13:31 |
| Complex Fields | suniljain | OpenFOAM | 1 | September 12, 2019 08:09 |
| [ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
| Hex and Tet meshes - simplefoam comparison | danvica | OpenFOAM Running, Solving & CFD | 10 | January 4, 2013 01:18 |
| Blockmesh cavity error message | tonitoney | OpenFOAM Installation | 2 | March 17, 2008 11:59 |
Linear Mode
