 |
 |
 |
|
|
|
[Sponsors] | ||||
[Other] ggi for non-overlaping interfaces (OpenFOAM-2.2) |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 6, 2013, 23:45
|
ggi for non-overlaping interfaces (OpenFOAM-2.2)
|
#1 |
|
New Member
|
Hello All,
I hope your day is going well. I am trying to solve a mesh problem as described in http://powerlab.fsb.hr/ped/kturbo/OP...asakHrvoje.pdf (case 2, dump case, mesh in the pic). Basically, it is a small-area nozzle connected to a big dump. Part of the interfaces are overlaping, the rest of the surface is supposed to be converted to wall. It seems using GGI interface could solve this problem. Could anyone point me to any tutorial if there exists one? or give me some instruction how I should treat such faces? I do not have much experience with OpenFOAM, especially the higher-versions. Any advice is welcome. Thanks, Xinyu |
|
|
|
|
|
January 13, 2017, 21:22
|
|
#2 |
|
Senior Member
khedar
Join Date: Oct 2016
Posts: 111
Rep Power: 9  |
Hi xinyu,
were you able to solve this tutorial? |
|
|
|
|
|
|
| Tags |
| ggi, non-overlapping, wall |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Getting Started with OpenFOAM | wyldckat | OpenFOAM | 25 | August 14, 2022 13:55 |
| Map of the OpenFOAM Forum - Understanding where to post your questions! | wyldckat | OpenFOAM | 10 | September 2, 2021 05:29 |
| [Other] interfaces in openfoam | Mo-ITB | OpenFOAM Meshing & Mesh Conversion | 0 | August 11, 2010 12:45 |
| problem with GGI interfaces | strider | CFX | 6 | May 29, 2006 14:20 |
| OpenFOAM Training and Workshop Zagreb 2628Jan2006 | hjasak | OpenFOAM | 1 | February 2, 2006 21:07 |
Linear Mode
