|April 23, 2012, 03:11||
different results for meshes produced by gambit and ICEM
Join Date: Nov 2011
Posts: 43Rep Power: 6
For a simple pipe flow,which size is 0.5X4,I used gambit and ICEM to produce .msh files.After converting the .msh files with command fluentMeshToFoam or fluent3DMeshToFoam,I ran the command icoFoam.What interested me is the big differences between the two case.And I found that the result with the mesh produced by gambit was correct,the other was wrong.
So who can tell me what is wrong with it?
|April 23, 2012, 08:15||
Join Date: May 2009
Location: Delft, Netherlands
Posts: 1,150Rep Power: 20
Please read: How to give enough info to get help
*On twitter @akidTwit
*Spend as much time formulating your questions as you expect people to spend on their answer.
*Join the OpenFOAM stackexchange Q&A site: http://area51.stackexchange.com/prop...oHPxcPqde7HtA2
|gambit and icem|
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Gambit to ICEM, any advices ?||Santos-Dumont||ANSYS Meshing & Geometry||15||February 28, 2012 20:07|
|[ICEM] Gambit to Openfoam, Gambit to ICEM to Openfoam||Rickard.Solsjo||ANSYS Meshing & Geometry||7||November 30, 2011 11:20|
|[ICEM] Export ICEM mesh to Gambit / Fluent||romekr||ANSYS Meshing & Geometry||1||November 26, 2011 13:11|
|Help: mesh conversion from Gambit to ICEM||sarah_ron2002||FLUENT||2||April 5, 2008 01:53|
|How to export gambit model to ICEM||Nirupama||Main CFD Forum||1||October 28, 2006 13:06|