 |
 |
 |
|
|
|
[Sponsors] | ||||
May 10, 2013, 08:00
|
Non-Orthogonal faces problem- Pointwise export to OpenFOAM
|
#1 |
|
New Member
Milad Ghaderi
Join Date: Feb 2013
Posts: 4
Rep Power: 2  |
Hi guys,
I am working on a complicated terrain. I have used pointwise to mesh the geometry and when I export to OpenFOAM it gives me warning about non-orthogonal faces. I have created almost 60M cells in one block and my terrain is the bottom of this cube. around 9000 non-orthogonal faces are found. Any idea how to solve this problem?  how do you reduce non-orthogonal faces in your cases? Of course I can run the case but the results are not reasonable. In addition, I have used structured mesh.BR Milad |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New OpenFOAM Forum Structure | jola | OpenFOAM | 2 | October 19, 2011 06:55 |
| Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6 | maverick | OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ... | 2 | June 18, 2011 04:36 |
| [ICEM] Problem with meshing (uncovered faces, can't export bocos) | hectordiaz | ANSYS Meshing & Geometry | 16 | May 13, 2011 06:36 |
| Pointwise grid export to Openfoam | Eren10 | OpenFOAM | 4 | January 10, 2011 06:43 |
| SnappyHexMesh for internal Flow | vishwa | OpenFOAM | 21 | February 27, 2010 03:47 |
Linear Mode
