 |
 |
 |
|
|
|
[Sponsors] | ||||
[Commercial meshers] ansysToFoam >> which file should I use? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 8, 2014, 22:23
|
ansysToFoam >> which file should I use?
|
#1 |
|
Member
Tommy Sp
Join Date: Jan 2014
Posts: 51
Rep Power: 12  |
Hi guys,
Which the mesh file that is produced by ansys should I use to use the conversion "ansysToFoam"? what the extent of it? where the meeting? can someone help me with at least one of these questions? thanks guys --------------- what is the file format? Last edited by wyldckat; May 18, 2014 at 16:20. Reason: merged two posts, since they were posted a few minutes apart |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| [foam-extend.org] problem when installing foam-extend-1.6 | Thomas pan | OpenFOAM Installation | 7 | September 9, 2015 21:53 |
| [swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0 | towanda | OpenFOAM Community Contributions | 6 | September 5, 2015 21:03 |
| "parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
| ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
Linear Mode
