 |
 |
 |
|
|
|
[Sponsors] | ||||
[Commercial meshers] CHT case meshing with Pointwise |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 17, 2014, 05:31
|
CHT case meshing with Pointwise
|
#1 |
|
New Member
akrasemann
Join Date: Dec 2013
Posts: 17
Rep Power: 12  |
Hi all,
is there anybody who has experience with Pointwise and mesh generation for CHT cases? At the moment I use blockMesh to generate my mesh, but my geometry is in fact not really simple. Therefore blockMesh is quite time consuming. Any experience on the Autodesk Inventor to Pointwise interface? Thanks Andreas |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh - 3D Wing Meshing Setup & Trials | denbjornen | OpenFOAM Meshing & Mesh Conversion | 1 | May 25, 2020 11:14 |
| Pointwise cylinder meshing | nilanka | Pointwise & Gridgen | 3 | August 21, 2017 08:51 |
| [Commercial meshers] Pointwise to Foam - cyclic BC points order | Pj. | OpenFOAM Meshing & Mesh Conversion | 5 | August 14, 2016 04:47 |
| How to Initialise my LES case using my RANS case is there any utility for it ? | Alhasan | OpenFOAM Running, Solving & CFD | 2 | May 10, 2014 00:14 |
| thin materials in cht case | sven82 | OpenFOAM Running, Solving & CFD | 0 | January 14, 2013 06:48 |
Linear Mode
